THE Soudal Panel System produced by Soudal Asia Pte Ltd is an efficient and sophisticated system for the permanent bonding of interior and exterior façade panels and roof edges.

It can also be applied for other interior renovation and building projects.

 

 

 

 

The Soudal Panel System consists of:

• Elastical adhesive/sealant         :  SPS Power Adhesive

• Primer for Wood                       :  SPS Wood Primer

• Cleaner                                    :  SPS Cleaner

• SPS Activator                           :  SPS Activator

• Double sided bonding tape         :  SPS Bonding Tape

 

Fixing wall panels with this adhesive system negates the possibility of visible screws or holes and there is less dirt pickup. It is also a safe system, which has a longer life span and higher mechanical strength.

 

SPS Wood Primer & Activator used in carrying Frame Construction

Soudal Panel System can be applied on both wooden and aluminium carrying frame constructions. The preparation is as follows:

 

Wood:

The smoothened wooden lathes need to be of at least B-quality. They must be clean, dry and have low moisture content. The lathes are initially treated with SPS Wood Primer. They must be left to dry for an hour after applying a thin covering layer and the panels have to be bonded within a day after the Primer has dried.

 

Aluminium:

The aluminium carrying frame construction must be cleaned and degreased with SPS Activator. This surface does not need any further priming. The bonding can start after complete evaporation of the SPS Activator, which has a drying time of 5 minutes.

 

SPS Wood Primer & Activator used in Facade Panels

Melanine panels and aluminium panels: The SPS Activator must be always be applied to the surfaces after they are thoroughly cleaned. It cleans, degreases and activates the surfaces of the panels to improve bonding strength of the adhesive/sealant.

 

Cementitious panels:

The surfaces of porous panels such as wooden or concrete panels must not be cleaned, but priming is required with SPS Wood Primer. The panels have to be bonded within a day after the Primer has dried.

 

SPS Bonding Tape

The SPS Bonding Tape is a double-sided bonding tape with high adhesive strength and is easy to apply manually or with a pneumatic gun. It ensures the initial fixing of the façade panel during the period the sealant/adhesive achieves its full cure. Due to its thickness, the SPS Bonding Tape ensures the correct and permanent adhesive thickness of 3mm. The SPS Bonding Tape is placed onto the vertical parts of the lathes of the carrying frame construction, after the primer is dry.

 

SPS Power Adhesive

The SPS Power Adhesive is used for bonding all types of façade panels, which can be applied either manually or with a pneumatic gun. It has high adhesive strength and remains fully elastic for a longer time span. Furthermore, it can withstand various weather conditions

 

SPS used in Advertising Panels

The SPS system and technique was used successfully in a Dutch project for bonding advertising panels made of aluminium.

The panels are bonded to the lattice but the advertising panel is not protected against wind and and precipitation. SPS Power Adhesive was used for bonding and the aluminium plates and frames were prepared with SPS Activator.